|
Rossi 01-20-2007, 12:08 PM Ok I think it's under the hood....passenger side....but figure I'll ask before I go out in the cold and look at it. All I really need right now is the Code off my ECU. I may get another one so I can get it tuned. I seem to remember a post on how to remove it...but I can't find it! suddenurge 01-20-2007, 12:13 PM I heard it's a pain to get to. It is on the passenger side near the firewall under something. Rossi 01-20-2007, 12:14 PM Yeah I think it's under the fuse box....I haven't walked out and looked yet....really I just need the number off it! buzzkillwill 01-20-2007, 12:29 PM You got the right spot, Rossi. shailey posted on how to remove it, but I don't remember which thread... baseballfanz 01-20-2007, 12:35 PM It's right by the fuse box under the hood. You will need to remove the fuse box to remove the ECU. Rossi 01-20-2007, 02:23 PM Ok....does anyone have a picture of a ECU.....I want to make sure I took the right part out!!! baseballfanz 01-20-2007, 02:32 PM I don't have an actual pictures but have one from the manual. Anything to do with Up Rev?:D Rossi 01-20-2007, 02:47 PM WEll it may.......I found a ECU...but the numbers are nothing alike.... This thing wasn't tooo hard to get out...just the bottom bolt on the ECU was a little fun. Here is the number off this ECU...nothing like the one I found. MEC84-211 A1 5Z27 Woo Hoo...reinstalled it and my truck still runs!!! LoL MDJamesD 01-20-2007, 05:29 PM Woo Hoo...reinstalled it and my truck still runs!!! LoL Now that's always an added bonus! Rossi 01-20-2007, 05:51 PM Yes it is....after pulling all the wiring off the fuse box...and some of them were hard to get off....I did worry a little!!! I just knew when I got it back together the thing wasn't going to run!! LoL But all was fine!! Ran some G-Tech runs to see if my ECU reset...but I don't think it did....with wheel spin I was pulling 15.15's....2.3 60' So at the track that would be 14.8ish. | ||