Does anyone have an idiot proof procedure for
removing the rear door panels on a crewcab??

Would give you a pic but the file is not supported so here you go.

Flat tip screwdriver and a philips is needed

1. Remove power switch assembly.
Disconnect harness connector
2. Remove pull handle cover
Remove screws behind pull handle cover
3. Remove cap from pull handle escutcheon and remove screw.
4. Remove pull handle escutcheon.
Remove screws behind pull handle escutcheon
5. Remove armrest
Remove screw behind armrest
6. Remove step lamp
Disconnect harness connector.
7. Pull off the panel and disconnect the door lock cables.
8. disconnect tweeter

It helps if you roll down your window first.
After step 5 I pulled off the door panel(held on by clips) A little jerk is needed.
The step lamp is easier to remove with the panel off.
then follow the rest.

Hope this helps

littlebuddha19, thanks for the help with the
door panels. I'm thinking about just replacing
the speakers starting with the rear. Almost
everyone says it doesn't do much good, but
I have a hard head.
TITAN57

you should also have 5 screws out of each door. If you don't the panel will not come off.

you should also have 5 screws out of each door. If you don't the panel will not come off.

6 screws in front doors and 5 screws in the rear.

littlebuddha19, thanks for the help with the
door panels. I'm thinking about just replacing
the speakers starting with the rear. Almost
everyone says it doesn't do much good, but
I have a hard head.
TITAN57

I replaced all of the main speakers in mine.
Factory size is 6x9 in the front and 6 1/2 in the rear.

if i was replacing the factory speakers i would not put 6x9s back in, i would change them to 6.1/2" components

Shouldn't littlebuddha's instructions be add to the how to section? Bixll, JT, and M4ck what do you all think. :D

Shouldn't littlebuddha's instructions be add to the how to section? Bixll, JT, and M4ck what do you all think. :D

Excellent idea, will do!!

How about getting the window lever off the front door? there isn't a screw... I don't have power windows, poor me!!

Shift-
Just curious about your 6x9 statement, why would you replace with 6.5 instead?

trooper

Does anyone have an idiot proof procedure for
removing the rear door panels on a crewcab??

Let me be funny here. I don't know if this will work for a Titan but the neighbors wife almost completely removed the door on hubby's vett by backing into the garage with the passenger door open. Sometimes you just have to stand there and laugh out loud. So I guess if you open the door and back into the garage at about 40 that should work . I have seen it.

DESTRO

How about getting the window lever off the front door? there isn't a screw... I don't have power windows, poor me!!

There is a little retainer clip that you have to get off. It's not that big of a deal, i've been successful with a rag but they do make a tool to do this. I got my tool from crutchfield.

http://www.crutchfield.com/S-uTEBO3vozgr/cgi-bin/ProdView.asp?g=820&I=18187615