Day three with the Titan and I was out of 200,000 acres of open training area at Fort Stewart GA. The first real stream I crossed and both front wheel wells popped off of their mounting screws. See attached pictures. The screw heads are too small to hold the wells when water pushes up from the back side. After getting home a simple addition of large rubber washers from Ace took care of the problem. Did wear away the corners of the well on the drive home. Other than that the truck did very well in some very sticky situations. Only into low one time.

Jared

I cringe every time I see a dirty Titan. LOL but I really wish I could afford an off road Titan. I think it would be a blast.

Dude, what were you doing out there, hunting or working? Me and my dad hunt out there also. I haven't this year because I haven't been able to get my pass yet.

On the subject though, watch out for the rear wheel wells also, there is one screw holding up the stuff in the back of the wheelwell, and Saturday I noticed mine was missing.

Hunting. I have not done any training at Ft Stewart for several years. But I enjoy using the area for hunting when I can get up from FL.

Jared

GREAT to see another dirty Titan!!! :D

I keep wanting to get mine off road, but just haven't had the time yet!

Thanks for the "heads-up" on the closeouts though!! :!: :wink: