Nissan Titan Forum banner

rear caliper bore size

1K views 3 replies 2 participants last post by  scr38 
#1 ·
hey guys i know i dont post up much on here but im doin a solid axle swap on my frontier and was hoping to use a titan master cylinder for the brakes

my question is can anyone tell me the piston size of the rear caliper ? wilwood carrier a caliper that may work for what i need but if the piston is a lot bigger than the titan rear caliper ill have to go a diff route , thanks

mods can move this to the wheels/brakes section?
 
#2 ·
The rear caliper has a bore of 48mm/1.89".
 
#4 ·
It is the same on all models.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top