Nissan Titan Forum banner

Time for Shocks/Struts/UCA's

5K views 6 replies 3 participants last post by  sht06 
#1 ·
MY 06 CC OR 4×4 is clocking 108, (+or-) is ready for suspension. My UCA seal gone on ball joint. My ? is do factory UCA and shock and struts which would be Ranchos factory. Should LCA's be done also. I'm all about factory.
But if I can upgrade cheaper to better any suggestions. The dealership I use will do all the work. I do plan on keeping the truck for a long time.

Thanks to the experts for your input.
 
#3 ·
#5 ·
Went with advice. Bilsteins great improvement. Ranchos dead as a door nail, rears completely dead at 108###. Front not much better. DYI simple took about 1 hour saved about 450$ dealer install cost. I use to turn wrenches on military aircraft so this was no challenge and saved enough on labor to pay for all 4 corners. Thanks for advise. Factory UCA'S dealer installed.
PRG PRODUCTS! Greg is the man thanks bud.
 
#6 ·
Glad it worked out so well. Can you post the part number of the rear shocks here - Front and Rear shocks?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top