Nissan Titan Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
To start i had the grommet(plastic piece) under the dash that connects the shifter cable break on me a few months ago and i bought a bushing kit to reconnect it. well, after a few days i started having an issue with it not engaging into reverse after it was warmed up or after it had been pulled down into reverse. but, after the truck has sit a few hours again it will go into reverse again until you put it into drive then the process starts all over again sadly!? sometimes before reverse engages it does kinda ramp up the rpms a little before it goes into reverse too. Anyone have this issue or hear of it before? any help would be greatly appreciated. Thanks in advance.
 
1 - 2 of 2 Posts
Top